Whites PCL 500 Bedienungsanleitung PDF herunterladen (Seite 40)

4. Using the Universal Print Driver

Search Settings

When using "Network Search", you can set detailed search parameters in the "Search

Settings" dialog box shown below.

Figure 4-2-11 Search Settings Dialog Box

The settings and their descriptions are described below.

Table 4-2-4 Details about Devices in the History View

Parameter Description

IP Version Specify the IP protocol version to give priority for searching.

IPv4 Priority Give priority to IPv4. This is the default for Windows Vista/

Server 2008 or later operating systems.

IPv6 Priority Give priority to IPv6.

IPv4 Only Only search for IPv4. “IPv4 Only” is the only choice available on

Windows 2000/XP/Server 2003 (other choices will be grayed

out).

IPv6 Only Only search for IPv6.

Subnet Settings Select this checkbox to set the subnet to search for. If this

checkbox is cleared, then IP address and subnet mask are

acquired for computers with UPD installed, and the search is

performed on that computer’s subnet. This cannot be set if

“IPv6 Only” is selected.

IP Address/Subnet Specify the IP address of the subnet to search.

Subnet Mask Specify the subnet mask of the subnet to search.

Search Method(IPv4) Specify the IPv4 search method. This is grayed out if “IPv6

Only” is selected.

Unicast Perform the search via unicast. This will make the search take

longer, because the computer will communicate with devices

on the network on a 1-to-1 basis. And also it may be possible to

detect devices that were not detected using a broadcast.

Broadcast Perform the search via broadcast. This reduces the search

time, because it communicates with all the devices on the

network at once.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Keine Kommentare

Whites PCL 500 Bedienungsanleitung Seite 40